Linux and sco on 2 seperate subarea

[CrazyRhAndSco]

i istalled sco opensever 5.05 on my drive ,and used the rest space for the rh7.3 . during my installation , i selected grub and installed it on the mbr .after the installation , i wanted to editor the /boot/grub/menu.lst to swich between the two operating system .but i found the following :

title Red Hat Linux
root (hd0,0)
kernel /boot/...... ro root=/dev/hda1
initrd /boot/.....
(sorry , i really remenber it entire,but it is enough)

i found it strangely .the rh7.3's subarea is (hd0,0);
but what is my SCO subarea :confused:
please tell me where i can find my SCO subarea
and if my SCO loader is broken ,does i have to reload
boot loader for the SCO,or i can use the GRUB only to slove the problem

please give my a advice
thanks a lot

[mdwatts]

What partition (hda#) did you install Openserver in?

I've seen documentation for dualbooting Openserver/OpenUnix with Grub when I was searching myself for setting up Linux and OpenUnix on the same pc. I have to leave for work in a couple of minutes, but will try to find the document while at the office and post back.

[mdwatts]

I'm having a hard time finding the document I used when setting up multi boot with Linux and OpenUnix.

Try searching Google for Linux ( www.google.com/linux ) for i.e. 'dual boot openserver' or 'dual boot openserver grub'.

One I did find 'Installing Linux on Compaq ProLiant Servers' from the above search results may help.