RH 7.3 install trouble

[seanxy]

I downloaded RH 7.3 ISO images and performed a installation from Hard Driver. After I inputed the ISO directory and then choiced OK, I got following error:

Error mounting /dev/loop1 on /mnt/runtime (Invalid argument)
This shouldn't happen, and I'm rebooting your system now.

I have tried to boot from a boot floppy and using Autoboot in DOS, but it's same. I have three FAT32 partition(C:,D:,E:) and an unallocatted partition (12G) is for RH. The ISO images are located in E:\redhat\, named cd1.iso, cd2.iso, and cd3.iso.

Any ideas how to deal this problem? Thanks for any help.

[mdwatts]

Where are you following the instructions from? Redhat's site?

Do they have anything on that error message?

[seanxy]

Fisrt, thank you for your tip. It sounds I don't need come here but just keep searching on Google. Second, I followed the offical RH installation guide to install and didn't find any information about this error, so I came here to ask for help. Also, I'm still trying my possible to find out the solution. Finally, If my question is stupid for some expert, I am sorry. But here is a Newbie Help fourm and I'm exactly a newbie. I expect someone who has some ideas gives me a hand. Thank you very much!

[mdwatts]

Are you referring to my signature?

In all the years I've been here at LNO, I have never seen that error message.

I was only asking if you were following specific instructions from Redhat.

If you had posted a link to the procedures, I was planning to look them over to see if I could help.

Sorry about that.