kowalsky
05-31-2001, 10:52 PM
Hi all,
I'm trying to set Highlight Mode for Perl in the Advanced Editor.
I go Settings -> Configure Highlight. In the Highlight Settings - KWrite tab I go at the Highlight Modes tab and at the Config Select section I pick Perl from the drop down list and .pl for the extension.
The Advanced Editor maintains these selections for one session, however if I open a new session I have to redo the whole settings again. What is my problem?!?!
Thanks a lot,
kowalsky
I'm trying to set Highlight Mode for Perl in the Advanced Editor.
I go Settings -> Configure Highlight. In the Highlight Settings - KWrite tab I go at the Highlight Modes tab and at the Config Select section I pick Perl from the drop down list and .pl for the extension.
The Advanced Editor maintains these selections for one session, however if I open a new session I have to redo the whole settings again. What is my problem?!?!
Thanks a lot,
kowalsky