jimriley
01-25-2004, 02:56 PM
Speedtouch adsl modem is not being found/recognised when plugged in or at boot by mdk9.2. Have been chasing this for a couple or three weeks.
On modem_run I get the following message:
Jan 25 15:07:51 localhost modem_run[3433]: Best offset 21 with probability 50%
Jan 25 15:07:51 localhost modem_run[3433]: Best offset 1 with probability 62%
Jan 25 15:07:53 localhost kernel: usb_control/bulk_msg: timeout
Jan 25 15:07:53 localhost kernel: usbdevfs: USBDEVFS_BULK failed dev 5 ep 0x85 len 512 ret -110
Jan 25 15:07:55 localhost kernel: usb_control/bulk_msg: timeout
Jan 25 15:07:55 localhost kernel: usbdevfs: USBDEVFS_BULK failed dev 5 ep 0x5 len 991 ret -110
Jan 25 15:07:55 localhost modem_run[3433]: BLOCK1
Jan 25 15:07:55 localhost modem_run[3433]: Retrying to upload microcode (#9)
which is showing that the firmware is not loaded to modem.
checked for usb driver/ awareness of modem with "lsmod" command. Nothing relevant shows up.
Others say mdk 9.2 recognised modem at first install. I have googled and tried varios methods to install software, including latest speedtouch mdk rpm i could find, reinstalled linux etc etc.
any ideas to get speedtouch usb module in place and running?
On modem_run I get the following message:
Jan 25 15:07:51 localhost modem_run[3433]: Best offset 21 with probability 50%
Jan 25 15:07:51 localhost modem_run[3433]: Best offset 1 with probability 62%
Jan 25 15:07:53 localhost kernel: usb_control/bulk_msg: timeout
Jan 25 15:07:53 localhost kernel: usbdevfs: USBDEVFS_BULK failed dev 5 ep 0x85 len 512 ret -110
Jan 25 15:07:55 localhost kernel: usb_control/bulk_msg: timeout
Jan 25 15:07:55 localhost kernel: usbdevfs: USBDEVFS_BULK failed dev 5 ep 0x5 len 991 ret -110
Jan 25 15:07:55 localhost modem_run[3433]: BLOCK1
Jan 25 15:07:55 localhost modem_run[3433]: Retrying to upload microcode (#9)
which is showing that the firmware is not loaded to modem.
checked for usb driver/ awareness of modem with "lsmod" command. Nothing relevant shows up.
Others say mdk 9.2 recognised modem at first install. I have googled and tried varios methods to install software, including latest speedtouch mdk rpm i could find, reinstalled linux etc etc.
any ideas to get speedtouch usb module in place and running?