dsalmon9
08-27-2003, 09:57 AM
Using RH9. Gnometoaster 1.0Beta 6. Using an HP CD Writer 8200 series, external USB drive. Attempting to burn an audio cd from mp3....installed all necessary addons, etc. When burning audio cd, it ALWAYS hangs at 7%. It will not finish a disc. Timer stops where it is.....Client output window reads,
Executing power calibration.....
Power calibration successful
Writing Track 01 (Audio/Audio)/...
That's it, it sits there like that....I hit stop in Gnometoaster window, it will not respond to any commands, stop or otherwise, it will only minimize. Noticed that it gives you the option to run a dummy disc. After having to reboot the machine as running the burner completely froze everything, I tried the dummy disc write. The Client output window reads as it did before with the following included:
Writing Track 01 (mode AUDIO/AUDIO)...
?: Input/Output error. : scsi sendcmd: no error
CDB: 2A 00 00 01 AB 00 00 17 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: FF 00 FF 00 FF 00 FF 00
Sense Key: 0xF Reserved, Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information)
Sense flags: Blk 16711935 (valid) file mark detected end of medium
illegal block length
cmd finished after 9.288s timeout 180s
ERROR: Write data failed.
ERROR: Writing failed -buffer under run?
ERROR: Simulation failed.
Does anyone have any idea about how to get this to work? Im complelely stuck here. I've searched, read the manual, I don't know what else to do. Please help if you have any idea about this. Thank you.
Executing power calibration.....
Power calibration successful
Writing Track 01 (Audio/Audio)/...
That's it, it sits there like that....I hit stop in Gnometoaster window, it will not respond to any commands, stop or otherwise, it will only minimize. Noticed that it gives you the option to run a dummy disc. After having to reboot the machine as running the burner completely froze everything, I tried the dummy disc write. The Client output window reads as it did before with the following included:
Writing Track 01 (mode AUDIO/AUDIO)...
?: Input/Output error. : scsi sendcmd: no error
CDB: 2A 00 00 01 AB 00 00 17 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: FF 00 FF 00 FF 00 FF 00
Sense Key: 0xF Reserved, Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information)
Sense flags: Blk 16711935 (valid) file mark detected end of medium
illegal block length
cmd finished after 9.288s timeout 180s
ERROR: Write data failed.
ERROR: Writing failed -buffer under run?
ERROR: Simulation failed.
Does anyone have any idea about how to get this to work? Im complelely stuck here. I've searched, read the manual, I don't know what else to do. Please help if you have any idea about this. Thank you.