NeilBlue
05-06-2003, 04:37 PM
Hello,
I have been using RH8 on a Compaq Evo N600c for a few months now, with a netgear MA401. The laptop also has an ethernet card built in. With RH8 I setup both eth0 and eth1. I only use eth1 (wireless) at home an only use eth0 (ethernet) at work.
I used to enable eth0 when needed, and eth1 worked when I plugged in the pcmcia card. But now with RH9 I find that the device names eth0 and eth1 keep changing for the devices when I reboot, after I have them working?
Also automount has stopped working. Is this a known problem to anyone?
Cheers
Neil
I have been using RH8 on a Compaq Evo N600c for a few months now, with a netgear MA401. The laptop also has an ethernet card built in. With RH8 I setup both eth0 and eth1. I only use eth1 (wireless) at home an only use eth0 (ethernet) at work.
I used to enable eth0 when needed, and eth1 worked when I plugged in the pcmcia card. But now with RH9 I find that the device names eth0 and eth1 keep changing for the devices when I reboot, after I have them working?
Also automount has stopped working. Is this a known problem to anyone?
Cheers
Neil